Chuango KP-700 Especificaciones

Printed in Hong KongPA: OI-KP700/EN-2013V1.0KP-700KeypadOperation ManualPlease read this manual carefully before use.Please keep it properly for furth

1615Power Saving ModeIf the keypad is powered by batteries, power saving mode is recommended. In power saving mode, the keypad is in sleeping status w

1817Change Admin CodeUsing admin code can wake up keypad, send Arm, Disarm, Stay Mode commands to the control panel, and also change any settings of t

2019UsageThe keypad can be used as a remote control. User code or admin code should be input before the operation of Arm, Disarm, Stay Mode, and Mute

2221Stay ModeInput user code or admin code, and press key, the LED indicator flashes once and the keypad beeps once and sends Stay Mode command to the

2423Care and MaintenanceIn order to avoid any harm to the users or others during usage and prolong the usage life, please abide by the following notic

2625Instructions of Wired Cables Interface (from Left to Right)+12V (RED WIRE):GND (BLACK WIRE):PUSH (YELLOW WIRE):GND (WHITE WIRE):OPEN (GREEN WIRE):

123-4566-788111210151613-1417189Table of ContentsIntroduction ForewordParts ListAppearancePreparation before UsePower onConnect Keypad to Control Pan

AAAAAAAAA1 2ForewordThank you for purchasing this wireless keypad. It is recommended to install outside the entry door and users can achieve operation

++++ ++++AAA3 4RFID TagAppearanceLED IndicatorRFID readerArmDisarmStay modeSOS keyRFID wake-up keyRFID tag / card (125KHz) can be purchased separate

1.5 6①②③2.AAA++1.Preparation before UsePower onKeypad uses 3pcs of AAA batteries.Loose the screw, open the casePut in batteries according to the posit

3.2.7 8①②Press , one beep is heard and the LED indicator is on. Keypad enters the learning state. [9]Put RFID tag close to the RFID reader, the connec

Input to wake up keypad.[admin code + #]9 10SettingsThe keypad should enter setup state before all settings.Enter Setup StatePress to enter setup

3 011 12Speed SOS DialUser can choose to enable or disable speed SOS dial. If speed SOS dial is enabled, the control panel will alarm immediately w

1413Disarm by RFID tagUser can enable or disable the function of disarming by RFID tag, or disarming silently by RFID tag.Enable Disarming by RFID Tag