Chuango G5 Manual de usuario descargar pdf (Pagina 24)

PCB Layout

AA 1.5V LR6

Infrared sensor

Zone setting

LED ON / OFF

Tamper switch

Usage

Infrared sensor:

Tamper switch:

It detects the infrared rays released by

human body motion, please don’t touch the surface and

always keep it clean.

Once the case is opened in working state,

the tamper switch will be triggered and then generates

an alarm signal.

Ope n the case and remov e the batter y activation strip to

activate batteries. It will start self-testing for one minute.

Mode Setting

Test Button

Testing mod e:

Working mod e:

Connect to alarm panel:

After self-testing, press the test button, the sensor enters testing

mod e, and detects once every 10 seconds. Af ter 3 minutes, the

LED flashes twice, and the sensor enters the working mod e.

In working state, if the sensor is triggered more than twice within

3 minutes, it will enter sleeping mod e to save power. After no

mov emen t within next 3 minutes, the sensor goes back to the

working mod e.

Press the connect key on the alarm panel, and then press the

test button of the sensor twice to send alarm signal. Whe n one

beep is heard, they are connected.

To check if they are connected successfully, arm the system, and

trigger the sensor again, if there is an alarming, the connection

is successful.

1 2 ... 19 20 21 22 23 24 25 26

Sin comentarios

Chuango G5 Manual de usuario Pagina 24